PFEP Tab

<< Click to Display Table of Contents >>

Navigation:  Tools Menu > Preferences >

PFEP Tab

This tab only applies to the optional PFEP (Plan For Every Part) module. PFEP is not included in the standard version of Assembly Planner.

PFEP snap

Options Menu Displaying used PFEP tab used to set default PFEP preferences

Dimension Unit sets the default dimension unit used in PFEP.

Weight Unit sets the default weight unit used in PFEP.

 

Default Work Schedule

The times displayed in reports exclude any scheduled breaks and down days. This means, for example, if a Kanban ID is requested fifteen minutes before a thirty minute break and is delivered 10 minutes after the break, the cycle time will be twenty-five rather than fifty-five.

The default schedule for PFEP is created here.

Exceptions to this work schedule are managed in Tools > Work Schedule Maintenance.

Shifts/Breaks

All three shifts must begin and end within the same 24-hour period. The third shift cannot start after midnight. In Assembly Planner, a 12:00 am to 6:00 am shift would need to be defined as 'Shift 1'.

Work Schedule Editor displaying PFEP Shifts Tab

Work Schedule Editor displaying PFEP Shifts Tab

Up to 12 breaks during a 24-hour period are accommodated. The breaks should be entered sequentially; they will automatically be assigned to the appropriate shift.

Work Schedule Editor displaying PFEP Breaks Tab

Work Schedule Editor displaying PFEP Breaks Tab

Holidays

Click 'Add' to enter the date and description of a holiday. These holidays are not specific to a year; any holidays for which the date changes from year to year (e.g. Thanksgiving, Memorial Day) will need to be modified each year, or handled in Tools > Work Schedule Maintenance.

Options-PFEP-Holidays